PEP/AVG LCD SWR/PWR meter indicator

LCD SWR PEP/AVG power meter  indicator for LDMOS MOSFET tube amplifier

The device is designed to display on the LCD alphanumeric display the values ​​of the forward power and  VSWR . For this purpose it should be connected to the directional coupler ( SWR bridge) of any design, say Tandem-match .
Thanks to peak detector on operational amplifier, this meter is capable to measure the PEP (peak envelope power) as well as average. The jumper on PCB is pre-set to PEP position, but it could be replaced by external selector to switch between PEP and AVG modes.
   The forward voltage must be applied to the input port F, reflected to input port R.
Power supply voltage is  +7.5...+15 volts.
Minimum voltage from directional coupler (SWR bridge)   +2.55V

   For proper operation the device requires calibration. Calibrate the Power Meter readout by trimmer FWR with reference meter. Calibrate the SWR readout by REV trimmer with reference meter connected in series to the antenna or using the dummy load with known resistance , 100 ohms for example. In this case, VSWR have to be set to 2.0:1 .
   Several pre-programmed  full-scale power levels are available, please inform what you need when order:
- 75W;
-150W;
-300W;
-600W;
-1200W;
-2400W.

max indicating power 2400W

Please make a selection of firmware to program into PIC.

If you do not make a choice, you will receive an indicator with a maximum of 2400 W program.

max indicating SWR 9.9:1

supply voltage +7.5 ... +15 VDC

requires SWR bridge (directional coupler)

has ports to connect LED and buzzer for alarm when VSWR rise up to 3.0:1 and higher

size 30 x 35 x 80 mm